Electronics Acoustic Guitar Electronics

Unleash the power of your Wavelength™ Solo under-saddle transducer with the Wavelength – Volume & Tone Module. This module puts the control of your volume level and tone-shaping right at your fingertips. A short cable connects the module to the Wavelength Solo endpin preamp, then it’s just a matter of mounting the unit to the inside of your guitar’s soundhole with an adhesive strip. No soldering or alteration to your instrument needed! Not only do you now have control of the volume and overall tone of your guitar, but there’s also no loss of tone or dampening of vibrations caused by batteries and electronics being attached to a side-mounted pre-amp assembly. This module is only for use with the Wavelength Solo: it is not compatible with the Wavelength Duo.Volume & Tone module for acoustic guitars with Wavelength Under-Saddle Transducercan be used with Wavelength Solo endpin preamp (not compatible with Wavelength Duo)for mounting on the inside of the soundholecontrols for volume, tone2 conductor cable with 3.5 mm jack plugNote: The right and refund policy does not apply to electronic components if their cables have been cut or soldered, if they show signs of use, if they have already been installed or other damage affecting the condition of the goods is present.Note: Replacement pickups may differ slightly in shape and dimensions from the original pickups. Adjustments may be necessary. It is recommended that you check the schematic drawings carefully. Deviations in the size and shape of the pickups do not constitute grounds for complaint. 

Replacement Shadow preamp for Traveler guitars, suitable for the AG-450E, AG-105E, AG-200E, CL-3E, CL-3EQ and CL-3BE models. The preamp features a 2-band equalizer and a phase-reverse switch for precise tone control. The volume control, as well as the bass and treble controls with center detent, allow accurate adjustment. The preamp also includes a built-in tuner, headphone output, and aux input. Pickup, output jack, battery compartment, and mounting screws are not included.replacement Shadow preamp for Traveler guitarssuitable for the AG-450E, AG-105E, AG-200E, CL-3E, CL-3EQ and CL-3BE models2-band equalizerphase-reverse switchcontrol for VolumeBass and Treble controls with center detentbuilt-in tuner, headphone output and aux inputpickup, output jack, battery compartment and mounting screws not included

Replacement preamp for Traveler guitars, suitable for the Original Escape models. The preamp features a 2-band equalizer for precise tone control. The volume control, as well as the bass and treble controls with center detent, allow accurate adjustment. The built-in output mode selector allows seamless switching between amp and headphone use. Mounting screws, connecting wires, output jack and battery clip are included.replacement preamp for Traveler guitarssuitable for the Original Escape models2-band equalizercontrol for VolumeBass and Treble controls with center detentoutput mode selector (amp or headphones)incl. mounting screws, connecting wires, output jack and battery clip

Replacement preamp for Traveler guitars, suitable for the Escape Mark III, Escape Mark III Nylon, Escape Classical, and Escape Concert models. The preamp features a 2-band equalizer and a phase-reverse switch for precise tone control. The volume control, as well as the bass and treble controls with center detent, allow accurate adjustment. The preamp also includes a built-in tuner, headphone output, and aux input. Pickup, output jack, battery compartment, and mounting screws are not included.replacement preamp for Traveler guitarssuitable for the Escape Mark III, Escape Mark III Nylon, Escape Classical and Escape Concert models2-band equalizerphase-reverse switchcontrol for VolumeBass and Treble controls with center detentbuilt-in tuner, headphone output and aux inputpickup, output jack, battery compartment and mounting screws not included

The Seymour Duncan Overture picks up the warmth and character of your instrument with startling clarity and accuracy, preserving its natural acoustic sound for live performance and direct-recording applications. The ceramic accelerometer is a very small and light device that is mounted to your guitars top and senses the complex vibrations of your guitar. Combined with the custom preamp, which is slightly larger than a 9V battery, get excellent dynamics and a very wide frequency response. This is a great pickup for percussive players and it works well for steel or nylon string instruments.piezo pickup with custom preamp for acoustic instrumentsfor steel-, nylon-, or 12-string guitarsincludes active preamp and output jackeasy fittingcompact designNote: The right and refund policy does not apply to electronic components if their cables have been cut or soldered, if they show signs of use, if they have already been installed or other damage affecting the condition of the goods is present.Note: Replacement pickups may differ slightly in shape and dimensions from the original pickups. Adjustments may be necessary. It is recommended that you check the schematic drawings carefully. Deviations in the size and shape of the pickups do not constitute grounds for complaint. 

The Multi-Source preamp system combines the popular Wave-Length pickup system (under-saddle transducer) with a condenser microphone for versatility, flexibility, and the most natural sound possible from your acoustic guitar. The Multi-Source uses the Wave-Length unitary design, piezoelectric co-polymer under-saddle pickup coupled to an 18-volt, low-noise, high-input impedance preamp with twice the dynamic range of typical 9-volt systems. Two AA batteries power the 18-volt preamp. With 18 volts, your signal has more headroom so hard strumming or plucking won’t distort into piezo quack as easily. With the addition of the highly efficient miniature, omni-directional electret condenser microphone, you can amplify your acoustic guitar with startling clarity and accuracy. The mic is nestled in a special absorptive visco-elastic polymer shock mount for optimal isolation. Two lightweight, low-profile knobs allow for master volume and microphone volume. Dial the microphone in to add just the right amount of air; dial it out to control feedback, if necessary. Speaking of feedback, the microphone channel has two stages of low frequency roll-off to combat any tendency towards low frequency feedback. Also, full coverage copper shielding on the pickup insures immunity to external noise fields.multi-source preamp system with under-saddle piezo pickup and omni-directional electret condenser microphone18V low-noise, high-input impedance preamp for more headroomactive operationsuitable for nylon string guitars2 stage low frequency filtering against low-end feedbackcontrols for master volume and microphone volumeinternal trim pots for bass and treble6.3 mm TRS endpin output jackcan be wired for either mono or stereo operationpower supply via 2 x AA batteriesNote: The right and refund policy does not apply to electronic components if their cables have been cut or soldered, if they show signs of use, if they have already been installed or other damage affecting the condition of the goods is present.Note: Replacement pickups may differ slightly in shape and dimensions from the original pickups. Adjustments may be necessary. It is recommended that you check the schematic drawings carefully. Deviations in the size and shape of the pickups do not constitute grounds for complaint. 

The Multi-Source preamp system combines the popular Wave-Length pickup system (under-saddle transducer) with a condenser microphone for versatility, flexibility, and the most natural sound possible from your western guitar. The Multi-Source uses the Wave-Length unitary design, piezoelectric co-polymer under-saddle pickup coupled to an 18-volt, low-noise, high-input impedance preamp with twice the dynamic range of typical 9-volt systems. Two AA batteries power the 18-volt preamp. With 18 volts, your signal has more headroom so hard strumming or plucking won’t distort into piezo quack as easily. With the addition of the highly efficient miniature, omni-directional electret condenser microphone, you can amplify your acoustic guitar with startling clarity and accuracy. The mic is nestled in a special absorptive visco-elastic polymer shock mount for optimal isolation. Two lightweight, low-profile knobs allow for master volume and microphone volume. Dial the microphone in to add just the right amount of air; dial it out to control feedback, if necessary. Speaking of feedback, the microphone channel has two stages of low frequency roll-off to combat any tendency towards low frequency feedback. Also, full coverage copper shielding on the pickup insures immunity to external noise fields.multi-source preamp system with under-saddle piezo pickup and omni-directional electret condenser microphone18V low-noise, high-input impedance preamp for more headroomactive operationsuitable for steel string guitars2 stage low frequency filtering against low-end feedbackcontrols for master volume and microphone volumeinternal trim pots for bass and treble6.3 mm TRS endpin output jackcan be wired for either mono or stereo operationpower supply via 2 x AA batteriesNote: Replacement pickups may differ slightly in shape and dimensions from the original pickups. Adjustments may be necessary. It is recommended that you check the schematic drawings carefully. Deviations in the size and shape of the pickups do not constitute grounds for complaint. 

This Wavelength Solo system avoids the typical under-saddle distortion found in piezo elements by combining a thin piezo polymer transducer with a low-noise, 18V, high-headroom preamp with twice the dynamic range of typical 9V pickup systems, letting you strum as aggressively as you like without those unpleasant sonic artifacts. The sound is full, balanced and clear. The preamp also has an input for a second source which gets routed directly to the ring connector at the jack, so you can add a soundhole pickup, mic or other pickup source. The Wavelength accommodates virtually all 6-string spacings, and works with most 12-string guitars as well. The element is easy to install in guitars with either 3/32” or 1/8” wide saddles, with typically no modification to the saddle slot. Add a plug-and-play Wavelength Vol & Tone Module for even more flexibility. The 18V preamp is powered by two AA batteries, and installation instructions are included.preamp system with under-saddle piezo pickup18V low-noise, high-headroom preamp active operationsuitable for nylon or steel string guitarsinternal trim pots for bass and treble6.3 mm TRS endpin output jackcan be wired for either mono or stereo operationpower supply via 2 x AA batteriesNote: The right and refund policy does not apply to electronic components if their cables have been cut or soldered, if they show signs of use, if they have already been installed or other damage affecting the condition of the goods is present.Note: Replacement pickups may differ slightly in shape and dimensions from the original pickups. Adjustments may be necessary. It is recommended that you check the schematic drawings carefully. Deviations in the size and shape of the pickups do not constitute grounds for complaint. 

Replacement preamp for Traveler guitars, suitable for the Escape Mark II Nylon model. The preamp features a 2-band equalizer for precise tone control. The volume control, as well as the bass and treble controls with center detent, allow accurate adjustment. The built-in output mode selector allows seamless switching between amp and headphone use. Piezo pickup, output jack, battery compartment, and mounting screws are not included.replacement preamp for Traveler guitarssuitable for the Escape Mark II Nylon model2-band equalizercontrol for VolumeBass and Treble controls with center detentoutput mode selector (amp or headphones)piezo pickup, output jack, battery compartment and mounting screws not included

Replacement preamp for Traveler guitars, suitable for the Escape Mark II Steel model. The preamp features a 2-band equalizer for precise tone control. The volume control, as well as the bass and treble controls with center detent, allow accurate adjustment. The built-in output mode selector allows seamless switching between amp and headphone use. Piezo pickup, output jack, battery compartment, and mounting screws are not included.replacement preamp for Traveler guitarssuitable for the Escape Mark II Steel model2-band equalizercontrol for VolumeBass and Treble controls with center detentoutput mode selector (amp or headphones)piezo pickup, output jack, battery compartment and mounting screws not included